#!/bin/sh # # Copyright (c) 2000 The FreeBSD Project # All rights reserved. # # Redistribution and use in source and binary forms, with or without # modification, are permitted provided that the following conditions # are met: # 1. Redistributions of source code must retain the above copyright # notice, this list of conditions and the following disclaimer. # 2. Redistributions in binary form must reproduce the above copyright # notice, this list of conditions and the following disclaimer in the # documentation and/or other materials provided with the distribution. # # THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND # ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE # IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE # ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE # FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL # DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS # OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) # HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT # LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY # OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF # SUCH DAMAGE. # # $FreeBSD$ # # PROVIDE: atm2 # REQUIRE: atm1 netif # BEFORE: routing # KEYWORD: nojail # # Additional ATM interface configuration # . /etc/rc.subr name="atm2" rcvar="atm_enable" start_cmd="atm2_start" stop_cmd=":" atm2_start() { # Configure network interfaces # get a list of physical interfaces atm_phy=`atm show stat int | { read junk ; read junk ; \ while read dev junk ; do case ${dev} in en[0-9] | en[0-9][0-9]) ;; *) echo "${dev} " ;; esac done ; }` for phy in ${atm_phy}; do eval netif_args=\$atm_netif_${phy} set -- ${netif_args} # skip unused physical interfaces if [ $# -lt 2 ] ; then continue fi netname=$1 netcnt=$2 netindx=0 while [ ${netindx} -lt ${netcnt} ]; do net="${netname}${netindx}" netindx=$((${netindx} + 1)) echo -n " ${net}" # Configure atmarp server eval atmarp_args=\$atm_arpserver_${net} if [ -n "${atmarp_args}" ]; then atm set arpserver ${net} ${atmarp_args} || continue fi done done echo '.' # Define any permanent ARP entries. if [ -n "${atm_arps}" ]; then for i in ${atm_arps}; do eval arp_args=\$atm_arp_${i} atm add arp ${arp_args} done fi } load_rc_config $name run_rc_command "$1" |