/*- * SPDX-License-Identifier: BSD-3-Clause * * Copyright (c) 2003-2009 RMI Corporation * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * 3. Neither the name of RMI Corporation, nor the names of its contributors, * may be used to endorse or promote products derived from this software * without specific prior written permission. * * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF * SUCH DAMAGE. * * $FreeBSD$ * RMI_BSD */ #ifndef _RMI_ATX_CPLD_H_ #define _RMI_ATX_CPLD_H_ /* * bit_0 : xgs0 phy reset, bit_1 : xgs1 phy reset, bit_2 : HT reset, bit_3 : * RTC reset, bit_4 : gmac phy soft reset, bit_5 : gmac phy hard reset, bit_6 * : board reset, bit_7 : reserved */ #define ATX_CPLD_RESET_1 2 /* * bit_0_2 : reserved, bit_3 : turn off xpak_0 tx, bit_4 : turn off xpak_1 * tx, bit_5 : HT stop (active low), bit_6 : flash program enable, bit_7 : * compact flash io mode */ #define ATX_CPLD_MISC_CTRL 8 /* * bit_0 : reset tcam, bit_1 : reset xpak_0 module, bit_2 : reset xpak_1 * module, bit_3_7 : reserved */ #define ATX_CPLD_RESET_2 9 #endif /* _RMI_ATX_CPLD_H_ */ |