.\" $NetBSD: gre.4,v 1.28 2002/06/10 02:49:35 itojun Exp $
.\"
.\" Copyright 1998 (c) The NetBSD Foundation, Inc.
.\" All rights reserved.
.\"
.\" This code is derived from software contributed to The NetBSD Foundation
.\" by Heiko W.Rupp <hwr@pilhuhn.de>
.\"
.\" Redistribution and use in source and binary forms, with or without
.\" modification, are permitted provided that the following conditions
.\" are met:
.\" 1. Redistributions of source code must retain the above copyright
.\"    notice, this list of conditions and the following disclaimer.
.\" 2. Redistributions in binary form must reproduce the above copyright
.\"    notice, this list of conditions and the following disclaimer in the
.\"    documentation and/or other materials provided with the distribution.
.\"
.\" THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
.\" ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
.\" TO, THE  IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
.\" PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
.\" BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
.\" CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
.\" SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
.\" INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
.\" CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
.\" ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
.\" POSSIBILITY OF SUCH DAMAGE.
.\"
.\" $FreeBSD$
.\"
.Dd August 21, 2020
.Dt GRE 4
.Os
.Sh NAME
.Nm gre
.Nd encapsulating network device
.Sh SYNOPSIS
To compile the
driver into the kernel, place the following line in the kernel
configuration file:
.Bd -ragged -offset indent
.Cd "device gre"
.Ed
.Pp
Alternatively, to load the
driver as a module at boot time, place the following line in
.Xr loader.conf 5 :
.Bd -literal -offset indent
if_gre_load="YES"
.Ed
.Sh DESCRIPTION
The
.Nm
network interface pseudo device encapsulates datagrams
into IP.
These encapsulated datagrams are routed to a destination host,
where they are decapsulated and further routed to their final destination.
The
.Dq tunnel
appears to the inner datagrams as one hop.
.Pp
.Nm
interfaces are dynamically created and destroyed with the
.Xr ifconfig 8
.Cm create
and
.Cm destroy
subcommands.
.Pp
This driver corresponds to RFC 2784.
Encapsulated datagrams are prepended an outer datagram and a GRE header.
The GRE header specifies
the type of the encapsulated datagram and thus allows for tunneling other
protocols than IP.
GRE mode is also the default tunnel mode on Cisco routers.
.Nm
also supports Cisco WCCP protocol, both version 1 and version 2.
.Pp
The
.Nm
interfaces support a number of additional parameters to the
.Xr ifconfig 8 :
.Bl -tag -width "enable_csum"
.It Ar grekey
Set the GRE key used for outgoing packets.
A value of 0 disables the key option.
.It Ar enable_csum
Enables checksum calculation for outgoing packets.
.It Ar enable_seq
Enables use of sequence number field in the GRE header for outgoing packets.
.It Ar udpencap
Enables UDP-in-GRE encapsulation (see the
.Sx GRE-IN-UDP ENCAPSULATION
Section below for details).
.It Ar udpport
Set the source UDP port for outgoing packets.
A value of 0 disables the persistence of source UDP port for outgoing packets.
See the
.Sx GRE-IN-UDP ENCAPSULATION
Section below for details.
.El
.Sh GRE-IN-UDP ENCAPSULATION
The
.Nm
supports GRE in UDP encapsulation as defined in RFC 8086.
A GRE in UDP tunnel offers the possibility of better performance for
load-balancing GRE traffic in transit networks.
Encapsulating GRE in UDP enables use of the UDP source port to provide
entropy to ECMP hashing.
.Pp
The GRE in UDP tunnel uses single value 4754 as UDP destination port.
The UDP source port contains a 14-bit entropy value that is generated
by the encapsulator to identify a flow for the encapsulated packet.
The
.Ar udpport
option can be used to disable this behaviour and use single source UDP
port value.
The value of
.Ar udpport
should be within the ephemeral port range, i.e., 49152 to 65535 by default.
.Pp
Note that a GRE in UDP tunnel is unidirectional; the tunnel traffic is not
expected to be returned back to the UDP source port values used to generate
entropy.
This may impact NAPT (Network Address Port Translator) middleboxes.
If such tunnels are expected to be used on a path with a middlebox,
the tunnel can be configured either to disable use of the UDP source port
for entropy or to enable middleboxes to pass packets with UDP source port
entropy.
.Sh EXAMPLES
.Bd -literal
192.168.1.* --- Router A  -------tunnel-------- Router B --- 192.168.2.*
                   \\                              /
                    \\                            /
                     +------ the Internet ------+
.Ed
.Pp
Assuming router A has the (external) IP address A and the internal address
192.168.1.1, while router B has external address B and internal address
192.168.2.1, the following commands will configure the tunnel:
.Pp
On router A:
.Bd -literal -offset indent
ifconfig greN create
ifconfig greN inet 192.168.1.1 192.168.2.1
ifconfig greN inet tunnel A B
route add -net 192.168.2 -netmask 255.255.255.0 192.168.2.1
.Ed
.Pp
On router B:
.Bd -literal -offset indent
ifconfig greN create
ifconfig greN inet 192.168.2.1 192.168.1.1
ifconfig greN inet tunnel B A
route add -net 192.168.1 -netmask 255.255.255.0 192.168.1.1
.Ed
.Pp
In case when internal and external IP addresses are the same,
different routing tables (FIB) should be used.
The default FIB will be applied to IP packets before GRE encapsulation.
After encapsulation GRE interface should set different FIB number to
outgoing packet.
Then different FIB will be applied to such encapsulated packets.
According to this FIB packet should be routed to tunnel endpoint.
.Bd -literal
Host X -- Host A (198.51.100.1) ---tunnel--- Cisco D (203.0.113.1) -- Host E
                   \\                                   /
                    \\                                 /
	             +----- Host B ----- Host C -----+
                       (198.51.100.254)
.Ed
.Pp
On Host A (FreeBSD):
.Pp
First of multiple FIBs should be configured via loader.conf:
.Bd -literal -offset indent
net.fibs=2
net.add_addr_allfibs=0
.Ed
.Pp
Then routes to the gateway and remote tunnel endpoint via this gateway
should be added to the second FIB:
.Bd -literal -offset indent
route add -net 198.51.100.0 -netmask 255.255.255.0 -fib 1 -iface em0
route add -host 203.0.113.1 -fib 1 198.51.100.254
.Ed
.Pp
And GRE tunnel should be configured to change FIB for encapsulated packets:
.Bd -literal -offset indent
ifconfig greN create
ifconfig greN inet 198.51.100.1 203.0.113.1
ifconfig greN inet tunnel 198.51.100.1 203.0.113.1 tunnelfib 1
.Ed
.Sh NOTES
The MTU of
.Nm
interfaces is set to 1476 by default, to match the value used by Cisco routers.
This may not be an optimal value, depending on the link between the two tunnel
endpoints.
It can be adjusted via
.Xr ifconfig 8 .
.Pp
For correct operation, the
.Nm
device needs a route to the decapsulating host that does not run over the tunnel,
as this would be a loop.
.Pp
The kernel must be set to forward datagrams by setting the
.Va net.inet.ip.forwarding
.Xr sysctl 8
variable to non-zero.
.Pp
By default,
.Nm
tunnels may not be nested.
This behavior may be modified at runtime by setting the
.Xr sysctl 8
variable
.Va net.link.gre.max_nesting
to the desired level of nesting.
.Sh SEE ALSO
.Xr gif 4 ,
.Xr inet 4 ,
.Xr ip 4 ,
.Xr me 4 ,
.Xr netintro 4 ,
.Xr protocols 5 ,
.Xr ifconfig 8 ,
.Xr sysctl 8
.Sh STANDARDS
.Rs
.%A S. Hanks
.%A "T. Li"
.%A D. Farinacci
.%A P. Traina
.%D October 1994
.%R RFC 1701
.%T Generic Routing Encapsulation (GRE)
.Re
.Pp
.Rs
.%A S. Hanks
.%A "T. Li"
.%A D. Farinacci
.%A P. Traina
.%D October 1994
.%R RFC 1702
.%T Generic Routing Encapsulation over IPv4 networks
.Re
.Pp
.Rs
.%A D. Farinacci
.%A "T. Li"
.%A S. Hanks
.%A D. Meyer
.%A P. Traina
.%D March 2000
.%R RFC 2784
.%T Generic Routing Encapsulation (GRE)
.Re
.Pp
.Rs
.%A G. Dommety
.%D September 2000
.%R RFC 2890
.%T Key and Sequence Number Extensions to GRE
.Re
.Sh AUTHORS
.An Andrey V. Elsukov Aq Mt ae@FreeBSD.org
.An Heiko W.Rupp Aq Mt hwr@pilhuhn.de
.Sh BUGS
The current implementation uses the key only for outgoing packets.
Incoming packets with a different key or without a key will be treated as if they
would belong to this interface.
.Pp
The sequence number field also used only for outgoing packets.