Training courses

Kernel and Embedded Linux

Bootlin training courses

Embedded Linux, kernel,
Yocto Project, Buildroot, real-time,
graphics, boot time, debugging...

Bootlin logo

Elixir Cross Referencer

# SPDX-License-Identifier: GPL-2.0-only
#
# Qualcomm network device configuration
#

config CONFIG_NET_VENDOR_QUALCOMM
	bool "Qualcomm devices"
	default y
	---help---
	  If you have a network (Ethernet) card belonging to this class, say Y.

	  Note that the answer to this question doesn't directly affect the
	  kernel: saying N will just cause the configurator to skip all
	  the questions about Qualcomm cards. If you say Y, you will be asked
	  for your specific card in the following questions.

if CONFIG_NET_VENDOR_QUALCOMM

config CONFIG_QCA7000
	tristate
	help
	  This enables support for the Qualcomm Atheros CONFIG_QCA7000.

config CONFIG_QCA7000_SPI
	tristate "Qualcomm Atheros QCA7000 SPI support"
	select CONFIG_QCA7000
	depends on CONFIG_SPI_MASTER && CONFIG_OF
	---help---
	  This CONFIG_SPI protocol driver supports the Qualcomm Atheros CONFIG_QCA7000.

	  To compile this driver as a module, choose CONFIG_M here. The module
	  will be called qcaspi.

config CONFIG_QCA7000_UART
	tristate "Qualcomm Atheros QCA7000 UART support"
	select CONFIG_QCA7000
	depends on CONFIG_SERIAL_DEV_BUS && CONFIG_OF
	---help---
	  This UART protocol driver supports the Qualcomm Atheros CONFIG_QCA7000.

	  Currently the driver assumes these device UART settings:
	    Data bits: 8
	    Parity: None
	    Stop bits: 1
	    Flow control: None

	  To compile this driver as a module, choose CONFIG_M here. The module
	  will be called qcauart.

config CONFIG_QCOM_EMAC
	tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support"
	depends on CONFIG_HAS_DMA && CONFIG_HAS_IOMEM
	select CONFIG_CRC32
	select CONFIG_PHYLIB
	---help---
	  This driver supports the Qualcomm Technologies, Inc. Gigabit
	  Ethernet Media Access Controller (EMAC). The controller
	  supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s,
	  full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for
	  low power, Receive-Side Scaling (RSS), and IEEE 1588-2008
	  Precision Clock Synchronization Protocol.

source "drivers/net/ethernet/qualcomm/rmnet/Kconfig"

endif # CONFIG_NET_VENDOR_QUALCOMM