menuconfig [31mCONFIG_MTD_ONENAND[0m tristate "OneNAND Device Support" depends on [31mCONFIG_MTD[0m depends on [31mCONFIG_HAS_IOMEM[0m help This enables support for accessing all type of OneNAND flash devices. For further information see <http://www.samsung.com/Products/Semiconductor/OneNAND/index.htm> if [31mCONFIG_MTD_ONENAND[0m config [31mCONFIG_MTD_ONENAND_VERIFY_WRITE[0m bool "Verify OneNAND page writes" help This adds an extra check when data is written to the flash. The OneNAND flash device internally checks only bits transitioning from 1 to 0. There is a rare possibility that even though the device thinks the write was successful, a bit could have been flipped accidentally due to device wear or something else. config [31mCONFIG_MTD_ONENAND_GENERIC[0m tristate "OneNAND Flash device via platform device driver" help Support for OneNAND flash via platform device driver. config [31mCONFIG_MTD_ONENAND_OMAP2[0m tristate "OneNAND on OMAP2/OMAP3 support" depends on [31mCONFIG_ARCH_OMAP2[0m || [31mCONFIG_ARCH_OMAP3[0m help Support for a OneNAND flash device connected to an OMAP2/OMAP3 CPU via the GPMC memory controller. config [31mCONFIG_MTD_ONENAND_SAMSUNG[0m tristate "OneNAND on Samsung SOC controller support" depends on [31mCONFIG_ARCH_S3C64XX[0m || [31mCONFIG_ARCH_S5PV210[0m || [31mCONFIG_ARCH_EXYNOS4[0m help Support for a OneNAND flash device connected to an Samsung SOC. S3C64XX uses command mapping method. S5PC110/S5PC210 use generic OneNAND method. config [31mCONFIG_MTD_ONENAND_OTP[0m bool "OneNAND OTP Support" help One Block of the NAND Flash Array memory is reserved as a One-Time Programmable Block memory area. Also, 1st Block of NAND Flash Array can be used as OTP. The OTP block can be read, programmed and locked using the same operations as any other NAND Flash Array memory block. OTP block cannot be erased. OTP block is fully-guaranteed to be a valid block. config [31mCONFIG_MTD_ONENAND_2X_PROGRAM[0m bool "OneNAND 2X program support" help The 2X Program is an extension of Program Operation. Since the device is equipped with two DataRAMs, and two-plane NAND Flash memory array, these two component enables simultaneous program of 4KiB. Plane1 has only even blocks such as block0, block2, block4 while Plane2 has only odd blocks such as block1, block3, block5. So [31mCONFIG_MTD[0m regards it as 4KiB page size and 256KiB block size Now the following chips support it. (KFXXX16Q2M) Demux: KFG2G16Q2M, KFH4G16Q2M, KFW8G16Q2M, Mux: KFM2G16Q2M, KFN4G16Q2M, And more recent chips endif # [31mCONFIG_MTD_ONENAND[0m |