Common i2c bus multiplexer/switch properties.

An i2c bus multiplexer/switch will have several child busses that are
numbered uniquely in a device dependent manner.  The nodes for an i2c bus
multiplexer/switch will have one child node for each child bus.

Optional properties:
- #address-cells = <1>;
   This property is required is the i2c-mux child node does not exist.

- #size-cells = <0>;
   This property is required is the i2c-mux child node does not exist.

- i2c-mux
   For i2c multiplexers/switches that have child nodes that are a mixture
   of both i2c child busses and other child nodes, the 'i2c-mux' subnode
   can be used for populating the i2c child busses.  If an 'i2c-mux'
   subnode is present, only subnodes of this will be considered as i2c
   child busses.

Required properties for the i2c-mux child node:
- #address-cells = <1>;
- #size-cells = <0>;

Required properties for i2c child bus nodes:
- #address-cells = <1>;
- #size-cells = <0>;
- reg : The sub-bus number.

Optional properties for i2c child bus nodes:
- Other properties specific to the multiplexer/switch hardware.
- Child nodes conforming to i2c bus binding


Example :

	/*
	   An NXP pca9548 8 channel I2C multiplexer at address 0x70
	   with two NXP pca8574 GPIO expanders attached, one each to
	   ports 3 and 4.
	 */

	mux@70 {
		compatible = "nxp,pca9548";
		reg = <0x70>;
		#address-cells = <1>;
		#size-cells = <0>;

		i2c@3 {
			#address-cells = <1>;
			#size-cells = <0>;
			reg = <3>;

			gpio1: gpio@38 {
				compatible = "nxp,pca8574";
				reg = <0x38>;
				#gpio-cells = <2>;
				gpio-controller;
			};
		};
		i2c@4 {
			#address-cells = <1>;
			#size-cells = <0>;
			reg = <4>;

			gpio2: gpio@38 {
				compatible = "nxp,pca8574";
				reg = <0x38>;
				#gpio-cells = <2>;
				gpio-controller;
			};
		};
	};