config [31mCONFIG_WLAN_VENDOR_RSI[0m bool "Redpine Signals Inc devices" default y ---help--- If you have a wireless card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about cards. If you say Y, you will be asked for your specific card in the following questions. if [31mCONFIG_WLAN_VENDOR_RSI[0m config [31mCONFIG_RSI_91X[0m tristate "Redpine Signals Inc 91x WLAN driver support" depends on [31mCONFIG_MAC80211[0m ---help--- This option enabes support for RSI 1x1 devices. Select [31mCONFIG_M[0m (recommended), if you have a RSI 1x1 wireless module. config [31mCONFIG_RSI_DEBUGFS[0m bool "Redpine Signals Inc debug support" depends on [31mCONFIG_RSI_91X[0m default y ---help--- Say Y, if you would like to enable debug support. This option creates debugfs entries config [31mCONFIG_RSI_SDIO[0m tristate "Redpine Signals SDIO bus support" depends on [31mCONFIG_MMC[0m && [31mCONFIG_RSI_91X[0m default m ---help--- This option enables the SDIO bus support in rsi drivers. Select [31mCONFIG_M[0m (recommended), if you have a RSI 1x1 wireless module. config [31mCONFIG_RSI_USB[0m tristate "Redpine Signals USB bus support" depends on [31mCONFIG_USB[0m && [31mCONFIG_RSI_91X[0m default m ---help--- This option enables the [31mCONFIG_USB[0m bus support in rsi drivers. Select [31mCONFIG_M[0m (recommended), if you have a RSI 1x1 wireless module. endif # [31mCONFIG_WLAN_VENDOR_RSI[0m |