/*
* PCIe host controller driver for Axis ARTPEC-6 SoC
*
* Author: Niklas Cassel <niklas.cassel@axis.com>
*
* Based on work done by Phil Edworthy <phil@edworthys.org>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/delay.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/pci.h>
#include <linux/platform_device.h>
#include <linux/resource.h>
#include <linux/signal.h>
#include <linux/types.h>
#include <linux/interrupt.h>
#include <linux/mfd/syscon.h>
#include <linux/regmap.h>
#include "pcie-designware.h"
#define to_artpec6_pcie(x) container_of(x, struct artpec6_pcie, pp)
struct artpec6_pcie {
struct pcie_port pp; /* pp.dbi_base is DT dbi */
struct regmap *regmap; /* DT axis,syscon-pcie */
void __iomem *phy_base; /* DT phy */
};
/* PCIe Port Logic registers (memory-mapped) */
#define PL_OFFSET 0x700
#define PCIE_PHY_DEBUG_R0 (PL_OFFSET + 0x28)
#define PCIE_PHY_DEBUG_R1 (PL_OFFSET + 0x2c)
#define MISC_CONTROL_1_OFF (PL_OFFSET + 0x1bc)
#define DBI_RO_WR_EN 1
/* ARTPEC-6 specific registers */
#define PCIECFG 0x18
#define PCIECFG_DBG_OEN (1 << 24)
#define PCIECFG_CORE_RESET_REQ (1 << 21)
#define PCIECFG_LTSSM_ENABLE (1 << 20)
#define PCIECFG_CLKREQ_B (1 << 11)
#define PCIECFG_REFCLK_ENABLE (1 << 10)
#define PCIECFG_PLL_ENABLE (1 << 9)
#define PCIECFG_PCLK_ENABLE (1 << 8)
#define PCIECFG_RISRCREN (1 << 4)
#define PCIECFG_MODE_TX_DRV_EN (1 << 3)
#define PCIECFG_CISRREN (1 << 2)
#define PCIECFG_MACRO_ENABLE (1 << 0)
#define NOCCFG 0x40
#define NOCCFG_ENABLE_CLK_PCIE (1 << 4)
#define NOCCFG_POWER_PCIE_IDLEACK (1 << 3)
#define NOCCFG_POWER_PCIE_IDLE (1 << 2)
#define NOCCFG_POWER_PCIE_IDLEREQ (1 << 1)
#define PHY_STATUS 0x118
#define PHY_COSPLLLOCK (1 << 0)
#define ARTPEC6_CPU_TO_BUS_ADDR 0x0fffffff
static u32 artpec6_pcie_readl(struct artpec6_pcie *artpec6_pcie, u32 offset)
{
u32 val;
regmap_read(artpec6_pcie->regmap, offset, &val);
return val;
}
static void artpec6_pcie_writel(struct artpec6_pcie *artpec6_pcie, u32 offset, u32 val)
{
regmap_write(artpec6_pcie->regmap, offset, val);
}
static int artpec6_pcie_establish_link(struct artpec6_pcie *artpec6_pcie)
{
struct pcie_port *pp = &artpec6_pcie->pp;
u32 val;
unsigned int retries;
/* Hold DW core in reset */
val = artpec6_pcie_readl(artpec6_pcie, PCIECFG);
val |= PCIECFG_CORE_RESET_REQ;
artpec6_pcie_writel(artpec6_pcie, PCIECFG, val);
val = artpec6_pcie_readl(artpec6_pcie, PCIECFG);
val |= PCIECFG_RISRCREN | /* Receiver term. 50 Ohm */
PCIECFG_MODE_TX_DRV_EN |
PCIECFG_CISRREN | /* Reference clock term. 100 Ohm */
PCIECFG_MACRO_ENABLE;
val |= PCIECFG_REFCLK_ENABLE;
val &= ~PCIECFG_DBG_OEN;
val &= ~PCIECFG_CLKREQ_B;
artpec6_pcie_writel(artpec6_pcie, PCIECFG, val);
usleep_range(5000, 6000);
val = artpec6_pcie_readl(artpec6_pcie, NOCCFG);
val |= NOCCFG_ENABLE_CLK_PCIE;
artpec6_pcie_writel(artpec6_pcie, NOCCFG, val);
usleep_range(20, 30);
val = artpec6_pcie_readl(artpec6_pcie, PCIECFG);
val |= PCIECFG_PCLK_ENABLE | PCIECFG_PLL_ENABLE;
artpec6_pcie_writel(artpec6_pcie, PCIECFG, val);
usleep_range(6000, 7000);
val = artpec6_pcie_readl(artpec6_pcie, NOCCFG);
val &= ~NOCCFG_POWER_PCIE_IDLEREQ;
artpec6_pcie_writel(artpec6_pcie, NOCCFG, val);
retries = 50;
do {
usleep_range(1000, 2000);
val = artpec6_pcie_readl(artpec6_pcie, NOCCFG);
retries--;
} while (retries &&
(val & (NOCCFG_POWER_PCIE_IDLEACK | NOCCFG_POWER_PCIE_IDLE)));
retries = 50;
do {
usleep_range(1000, 2000);
val = readl(artpec6_pcie->phy_base + PHY_STATUS);
retries--;
} while (retries && !(val & PHY_COSPLLLOCK));
/* Take DW core out of reset */
val = artpec6_pcie_readl(artpec6_pcie, PCIECFG);
val &= ~PCIECFG_CORE_RESET_REQ;
artpec6_pcie_writel(artpec6_pcie, PCIECFG, val);
usleep_range(100, 200);
/*
* Enable writing to config regs. This is required as the Synopsys
* driver changes the class code. That register needs DBI write enable.
*/
dw_pcie_writel_rc(pp, MISC_CONTROL_1_OFF, DBI_RO_WR_EN);
pp->io_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->mem_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->cfg0_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->cfg1_base &= ARTPEC6_CPU_TO_BUS_ADDR;
/* setup root complex */
dw_pcie_setup_rc(pp);
/* assert LTSSM enable */
val = artpec6_pcie_readl(artpec6_pcie, PCIECFG);
val |= PCIECFG_LTSSM_ENABLE;
artpec6_pcie_writel(artpec6_pcie, PCIECFG, val);
/* check if the link is up or not */
if (!dw_pcie_wait_for_link(pp))
return 0;
dev_dbg(pp->dev, "DEBUG_R0: 0x%08x, DEBUG_R1: 0x%08x\n",
dw_pcie_readl_rc(pp, PCIE_PHY_DEBUG_R0),
dw_pcie_readl_rc(pp, PCIE_PHY_DEBUG_R1));
return -ETIMEDOUT;
}
static void artpec6_pcie_enable_interrupts(struct artpec6_pcie *artpec6_pcie)
{
struct pcie_port *pp = &artpec6_pcie->pp;
if (IS_ENABLED([31mCONFIG_PCI_MSI[0m))
dw_pcie_msi_init(pp);
}
static void artpec6_pcie_host_init(struct pcie_port *pp)
{
struct artpec6_pcie *artpec6_pcie = to_artpec6_pcie(pp);
artpec6_pcie_establish_link(artpec6_pcie);
artpec6_pcie_enable_interrupts(artpec6_pcie);
}
static struct pcie_host_ops artpec6_pcie_host_ops = {
.host_init = artpec6_pcie_host_init,
};
static irqreturn_t artpec6_pcie_msi_handler(int irq, void *arg)
{
struct artpec6_pcie *artpec6_pcie = arg;
struct pcie_port *pp = &artpec6_pcie->pp;
return dw_handle_msi_irq(pp);
}
static int artpec6_add_pcie_port(struct artpec6_pcie *artpec6_pcie,
struct platform_device *pdev)
{
struct pcie_port *pp = &artpec6_pcie->pp;
struct device *dev = pp->dev;
int ret;
if (IS_ENABLED([31mCONFIG_PCI_MSI[0m)) {
pp->msi_irq = platform_get_irq_byname(pdev, "msi");
if (pp->msi_irq <= 0) {
dev_err(dev, "failed to get MSI irq\n");
return -ENODEV;
}
ret = devm_request_irq(dev, pp->msi_irq,
artpec6_pcie_msi_handler,
IRQF_SHARED | IRQF_NO_THREAD,
"artpec6-pcie-msi", artpec6_pcie);
if (ret) {
dev_err(dev, "failed to request MSI irq\n");
return ret;
}
}
pp->root_bus_nr = -1;
pp->ops = &artpec6_pcie_host_ops;
ret = dw_pcie_host_init(pp);
if (ret) {
dev_err(dev, "failed to initialize host\n");
return ret;
}
return 0;
}
static int artpec6_pcie_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
struct artpec6_pcie *artpec6_pcie;
struct pcie_port *pp;
struct resource *dbi_base;
struct resource *phy_base;
int ret;
artpec6_pcie = devm_kzalloc(dev, sizeof(*artpec6_pcie), GFP_KERNEL);
if (!artpec6_pcie)
return -ENOMEM;
pp = &artpec6_pcie->pp;
pp->dev = dev;
dbi_base = platform_get_resource_byname(pdev, IORESOURCE_MEM, "dbi");
pp->dbi_base = devm_ioremap_resource(dev, dbi_base);
if (IS_ERR(pp->dbi_base))
return PTR_ERR(pp->dbi_base);
phy_base = platform_get_resource_byname(pdev, IORESOURCE_MEM, "phy");
artpec6_pcie->phy_base = devm_ioremap_resource(dev, phy_base);
if (IS_ERR(artpec6_pcie->phy_base))
return PTR_ERR(artpec6_pcie->phy_base);
artpec6_pcie->regmap =
syscon_regmap_lookup_by_phandle(dev->of_node,
"axis,syscon-pcie");
if (IS_ERR(artpec6_pcie->regmap))
return PTR_ERR(artpec6_pcie->regmap);
ret = artpec6_add_pcie_port(artpec6_pcie, pdev);
if (ret < 0)
return ret;
return 0;
}
static const struct of_device_id artpec6_pcie_of_match[] = {
{ .compatible = "axis,artpec6-pcie", },
{},
};
static struct platform_driver artpec6_pcie_driver = {
.probe = artpec6_pcie_probe,
.driver = {
.name = "artpec6-pcie",
.of_match_table = artpec6_pcie_of_match,
},
};
builtin_platform_driver(artpec6_pcie_driver);