* Samsung Exynos 5440 PCIe interface This PCIe host controller is based on the Synopsis Designware PCIe IP and thus inherits all the common properties defined in designware-pcie.txt. Required properties: - compatible: "samsung,exynos5440-pcie" - reg: base addresses and lengths of the pcie controller, the phy controller, additional register for the phy controller. - interrupts: A list of interrupt outputs for level interrupt, pulse interrupt, special interrupt. Example: SoC specific DT Entry: pcie@290000 { compatible = "samsung,exynos5440-pcie", "snps,dw-pcie"; reg = <0x290000 0x1000 0x270000 0x1000 0x271000 0x40>; interrupts = <0 20 0>, <0 21 0>, <0 22 0>; clocks = <&clock 28>, <&clock 27>; clock-names = "pcie", "pcie_bus"; #address-cells = <3>; #size-cells = <2>; device_type = "pci"; ranges = <0x00000800 0 0x40000000 0x40000000 0 0x00001000 /* configuration space */ 0x81000000 0 0 0x40001000 0 0x00010000 /* downstream I/O */ 0x82000000 0 0x40011000 0x40011000 0 0x1ffef000>; /* non-prefetchable memory */ #interrupt-cells = <1>; interrupt-map-mask = <0 0 0 0>; interrupt-map = <0 0 0 0 &gic GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>; num-lanes = <4>; }; pcie@2a0000 { compatible = "samsung,exynos5440-pcie", "snps,dw-pcie"; reg = <0x2a0000 0x1000 0x272000 0x1000 0x271040 0x40>; interrupts = <0 23 0>, <0 24 0>, <0 25 0>; clocks = <&clock 29>, <&clock 27>; clock-names = "pcie", "pcie_bus"; #address-cells = <3>; #size-cells = <2>; device_type = "pci"; ranges = <0x00000800 0 0x60000000 0x60000000 0 0x00001000 /* configuration space */ 0x81000000 0 0 0x60001000 0 0x00010000 /* downstream I/O */ 0x82000000 0 0x60011000 0x60011000 0 0x1ffef000>; /* non-prefetchable memory */ #interrupt-cells = <1>; interrupt-map-mask = <0 0 0 0>; interrupt-map = <0 0 0 0 &gic GIC_SPI 24 IRQ_TYPE_LEVEL_HIGH>; num-lanes = <4>; }; Board specific DT Entry: pcie@290000 { reset-gpio = <&pin_ctrl 5 0>; }; pcie@2a0000 { reset-gpio = <&pin_ctrl 22 0>; }; |