# # Adaptec network device configuration # config [31mCONFIG_NET_VENDOR_ADAPTEC[0m bool "Adaptec devices" default y depends on [31mCONFIG_PCI[0m ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Adaptec cards. If you say Y, you will be asked for your specific card in the following questions. if [31mCONFIG_NET_VENDOR_ADAPTEC[0m config [31mCONFIG_ADAPTEC_STARFIRE[0m tristate "Adaptec Starfire/DuraLAN support" depends on [31mCONFIG_PCI[0m select [31mCONFIG_CRC32[0m select [31mCONFIG_MII[0m ---help--- Say Y here if you have an Adaptec Starfire (or DuraLAN) [31mCONFIG_PCI[0m network adapter. The DuraLAN chip is used on the 64 bit [31mCONFIG_PCI[0m boards from Adaptec e.g. the ANA-6922A. The older 32 bit boards use the tulip driver. To compile this driver as a module, choose [31mCONFIG_M[0m here: the module will be called starfire. This is recommended. endif # [31mCONFIG_NET_VENDOR_ADAPTEC[0m |