Renesas RZ/A2 combined Pin and GPIO controller

The Renesas SoCs of the RZ/A2 series feature a combined Pin and GPIO controller.
Pin multiplexing and GPIO configuration is performed on a per-pin basis.
Each port features up to 8 pins, each of them configurable for GPIO
function (port mode) or in alternate function mode.
Up to 8 different alternate function modes exist for each single pin.

Pin controller node
-------------------

Required properties:
  - compatible: shall be:
    - "renesas,r7s9210-pinctrl": for RZ/A2M
  - reg
    Address base and length of the memory area where the pin controller
    hardware is mapped to.
  - gpio-controller
    This pin controller also controls pins as GPIO
  - #gpio-cells
    Must be 2
  - gpio-ranges
    Expresses the total number of GPIO ports/pins in this SoC

Example: Pin controller node for RZ/A2M SoC (r7s9210)

	pinctrl: pin-controller@fcffe000 {
		compatible = "renesas,r7s9210-pinctrl";
		reg = <0xfcffe000 0x1000>;

		gpio-controller;
		#gpio-cells = <2>;
		gpio-ranges = <&pinctrl 0 0 176>;
	};

Sub-nodes
---------

The child nodes of the pin controller designate pins to be used for
specific peripheral functions or as GPIO.

- Pin multiplexing sub-nodes:
  A pin multiplexing sub-node describes how to configure a set of
  (or a single) pin in some desired alternate function mode.
  The values for the pinmux properties are a combination of port name, pin
  number and the desired function index. Use the RZA2_PINMUX macro located
  in include/dt-bindings/pinctrl/r7s9210-pinctrl.h to easily define these.
  For assigning GPIO pins, use the macro RZA2_PIN also in r7s9210-pinctrl.h
  to express the desired port pin.

  Required properties:
    - pinmux:
      integer array representing pin number and pin multiplexing configuration.
      When a pin has to be configured in alternate function mode, use this
      property to identify the pin by its global index, and provide its
      alternate function configuration number along with it.
      When multiple pins are required to be configured as part of the same
      alternate function they shall be specified as members of the same
      argument list of a single "pinmux" property.
      Helper macros to ease assembling the pin index from its position
      (port where it sits on and pin number) and alternate function identifier
      are provided by the pin controller header file at:
      <dt-bindings/pinctrl/r7s9210-pinctrl.h>
      Integers values in "pinmux" argument list are assembled as:
      ((PORT * 8 + PIN) | MUX_FUNC << 16)

  Example: Board specific pins configuration

	&pinctrl {
		/* Serial Console */
		scif4_pins: serial4 {
			pinmux = <RZA2_PINMUX(PORT9, 0, 4)>,	/* TxD4 */
				 <RZA2_PINMUX(PORT9, 1, 4)>;	/* RxD4 */
		};
	};

  Example: Assigning a GPIO:

	leds {
		status = "okay";
		compatible = "gpio-leds";

		led0 {
			/* P6_0 */
			gpios = <&pinctrl RZA2_PIN(PORT6, 0) GPIO_ACTIVE_HIGH>;
		};
	};