# SPDX-License-Identifier: GPL-2.0-only # # [31mCONFIG_HIPPI[0m network device configuration # config [31mCONFIG_HIPPI[0m bool "HIPPI driver support" depends on [31mCONFIG_INET[0m && [31mCONFIG_PCI[0m ---help--- HIgh Performance Parallel Interface ([31mCONFIG_HIPPI[0m) is a 800Mbit/sec and 1600Mbit/sec dual-simplex switched or point-to-point network. [31mCONFIG_HIPPI[0m can run over copper (25m) or fiber (300m on multi-mode or 10km on single-mode). [31mCONFIG_HIPPI[0m networks are commonly used for clusters and to connect to super computers. If you are connected to a [31mCONFIG_HIPPI[0m network and have a [31mCONFIG_HIPPI[0m network card in your computer that you want to use under Linux, say Y here (you must also remember to enable the driver for your [31mCONFIG_HIPPI[0m card below). Most people will say N here. if [31mCONFIG_HIPPI[0m config [31mCONFIG_ROADRUNNER[0m tristate "Essential RoadRunner HIPPI PCI adapter support" depends on [31mCONFIG_PCI[0m ---help--- Say Y here if this is your [31mCONFIG_PCI[0m [31mCONFIG_HIPPI[0m network card. To compile this driver as a module, choose [31mCONFIG_M[0m here: the module will be called rrunner. If unsure, say N. config [31mCONFIG_ROADRUNNER_LARGE_RINGS[0m bool "Use large TX/RX rings" depends on [31mCONFIG_ROADRUNNER[0m ---help--- If you say Y here, the RoadRunner driver will preallocate up to 2 MB of additional memory to allow for fastest operation, both for transmitting and receiving. This memory cannot be used by any other kernel code or by user space programs. Say Y here only if you have the memory. endif # [31mCONFIG_HIPPI[0m |