# SPDX-License-Identifier: GPL-2.0-only # # [31mCONFIG_MMC[0m core configuration # config [31mCONFIG_PWRSEQ_EMMC[0m tristate "HW reset support for eMMC" default y depends on [31mCONFIG_OF[0m help This selects Hardware reset support aka pwrseq-emmc for eMMC devices. By default this option is set to y. This driver can also be built as a module. If so, the module will be called pwrseq_emmc. config [31mCONFIG_PWRSEQ_SD8787[0m tristate "HW reset support for SD8787 BT + Wifi module" depends on [31mCONFIG_OF[0m && ([31mCONFIG_MWIFIEX[0m || [31mCONFIG_BT_MRVL_SDIO[0m || [31mCONFIG_LIBERTAS_SDIO[0m) help This selects hardware reset support for the SD8787 [31mCONFIG_BT[0m + Wifi module. By default this option is set to n. This driver can also be built as a module. If so, the module will be called pwrseq_sd8787. config [31mCONFIG_PWRSEQ_SIMPLE[0m tristate "Simple HW reset support for MMC" default y depends on [31mCONFIG_OF[0m help This selects simple hardware reset support aka pwrseq-simple for [31mCONFIG_MMC[0m devices. By default this option is set to y. This driver can also be built as a module. If so, the module will be called pwrseq_simple. config [31mCONFIG_MMC_BLOCK[0m tristate "MMC block device driver" depends on [31mCONFIG_BLOCK[0m default y help Say Y here to enable the [31mCONFIG_MMC[0m block device driver support. This provides a block device driver, which you can use to mount the filesystem. Almost everyone wishing [31mCONFIG_MMC[0m support should say Y or [31mCONFIG_M[0m here. config [31mCONFIG_MMC_BLOCK_MINORS[0m int "Number of minors per block device" depends on [31mCONFIG_MMC_BLOCK[0m range 4 256 default 8 help Number of minors per block device. One is needed for every partition on the disk (plus one for the whole disk). Number of total [31mCONFIG_MMC[0m minors available is 256, so your number of supported block devices will be limited to 256 divided by this number. Default is 8 to be backwards compatible with previous hardwired device numbering. If unsure, say 8 here. config [31mCONFIG_SDIO_UART[0m tristate "SDIO UART/GPS class support" depends on [31mCONFIG_TTY[0m help SDIO function driver for SDIO cards that implements the UART class, as well as the GPS class which appears like a UART. config [31mCONFIG_MMC_TEST[0m tristate "MMC host test driver" help Development driver that performs a series of reads and writes to a memory card in order to expose certain well known bugs in host controllers. The tests are executed by writing to the "test" file in debugfs under each card. Note that whatever is on your card will be overwritten by these tests. This driver is only of interest to those developing or testing a host driver. Most people should say N here. |