Training courses

Kernel and Embedded Linux

Bootlin training courses

Embedded Linux, kernel,
Yocto Project, Buildroot, real-time,
graphics, boot time, debugging...

Bootlin logo

Elixir Cross Referencer

# SPDX-License-Identifier: GPL-2.0
config CONFIG_WILC1000
	tristate
	help
	  This module only support IEEE 802.11n WiFi.

config CONFIG_WILC1000_SDIO
	tristate "Atmel WILC1000 SDIO (WiFi only)"
	depends on CONFIG_CFG80211 && CONFIG_INET && CONFIG_MMC
	select CONFIG_WILC1000
	help
	  This module adds support for the SDIO interface of adapters using
	  CONFIG_WILC1000 chipset. The Atmel CONFIG_WILC1000 SDIO is a full speed interface.
	  It meets SDIO card specification version 2.0. The interface supports
	  the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz.
	  The host can use this interface to read and write from any register
	  within the chip as well as configure the CONFIG_WILC1000 for data DMA.
	  To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select
	  this if your platform is using the SDIO bus.

config CONFIG_WILC1000_SPI
	tristate "Atmel WILC1000 SPI (WiFi only)"
	depends on CONFIG_CFG80211 && CONFIG_INET && CONFIG_SPI
	select CONFIG_WILC1000
	help
	  This module adds support for the CONFIG_SPI interface of adapters using
	  CONFIG_WILC1000 chipset. The Atmel CONFIG_WILC1000 has a Serial Peripheral
	  Interface (CONFIG_SPI) that operates as a CONFIG_SPI slave. This CONFIG_SPI interface can
	  be used for control and for serial I/O of 802.11 data. The CONFIG_SPI is a
	  full-duplex slave synchronous serial interface that is available
	  immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
	  VDDIO. Select this if your platform is using the CONFIG_SPI bus.

config CONFIG_WILC1000_HW_OOB_INTR
	bool "WILC1000 out of band interrupt"
	depends on CONFIG_WILC1000_SDIO
	help
	  This option enables out-of-band interrupt support for the CONFIG_WILC1000
	  chipset. This OOB interrupt is intended to provide a faster interrupt
	  mechanism for SDIO host controllers that don't support SDIO interrupt.
	  Select this option If the SDIO host controller in your platform
	  doesn't support SDIO time devision interrupt.