/* SPDX-License-Identifier: GPL-2.0-or-later */ /* * bsbe1.h - ALPS BSBE1 tuner support * * the project's page is at https://linuxtv.org */ #ifndef BSBE1_H #define BSBE1_H static u8 alps_bsbe1_inittab[] = { 0x01, 0x15, /* XTAL = 4MHz, VCO = 352 MHz */ 0x02, 0x30, /* MCLK = 88 MHz */ 0x03, 0x00, /* ACR output 0 */ 0x04, 0x7d, /* F22FR = 0x7d, F22 = f_VCO / 128 / 0x7d = 22 kHz */ 0x05, 0x05, /* I2CT = 0, SCLT = 1, SDAT = 1 */ 0x06, 0x00, /* DAC output 0 */ 0x08, 0x40, /* DiSEqC off, LNB power on OP2/LOCK pin on */ 0x09, 0x00, /* FIFO */ 0x0c, 0x51, /* OP1/OP0 normal, val = 1 (LNB power on) */ 0x0d, 0x82, /* DC offset compensation = on, beta_agc1 = 2 */ 0x0f, 0x92, /* AGC1R */ 0x10, 0x34, /* AGC2O */ 0x11, 0x84, /* TLSR */ 0x12, 0xb9, /* CFD */ 0x15, 0xc9, /* lock detector threshold */ 0x28, 0x00, /* out imp: normal, type: parallel, FEC mode: QPSK */ 0x33, 0xfc, /* RS control */ 0x34, 0x93, /* count viterbi bit errors per 2E18 bytes */ 0xff, 0xff }; static int alps_bsbe1_set_symbol_rate(struct dvb_frontend* fe, u32 srate, u32 ratio) { u8 aclk = 0; u8 bclk = 0; if (srate < 1500000) { aclk = 0xb7; bclk = 0x47; } else if (srate < 3000000) { aclk = 0xb7; bclk = 0x4b; } else if (srate < 7000000) { aclk = 0xb7; bclk = 0x4f; } else if (srate < 14000000) { aclk = 0xb7; bclk = 0x53; } else if (srate < 30000000) { aclk = 0xb6; bclk = 0x53; } else if (srate < 45000000) { aclk = 0xb4; bclk = 0x51; } stv0299_writereg(fe, 0x13, aclk); stv0299_writereg(fe, 0x14, bclk); stv0299_writereg(fe, 0x1f, (ratio >> 16) & 0xff); stv0299_writereg(fe, 0x20, (ratio >> 8) & 0xff); stv0299_writereg(fe, 0x21, (ratio ) & 0xf0); return 0; } static int alps_bsbe1_tuner_set_params(struct dvb_frontend *fe) { struct dtv_frontend_properties *p = &fe->dtv_property_cache; int ret; u8 data[4]; u32 div; struct i2c_msg msg = { .addr = 0x61, .flags = 0, .buf = data, .len = sizeof(data) }; struct i2c_adapter *i2c = fe->tuner_priv; if ((p->frequency < 950000) || (p->frequency > 2150000)) return -EINVAL; div = p->frequency / 1000; data[0] = (div >> 8) & 0x7f; data[1] = div & 0xff; data[2] = 0x80 | ((div & 0x18000) >> 10) | 0x1; data[3] = 0xe0; if (fe->ops.i2c_gate_ctrl) fe->ops.i2c_gate_ctrl(fe, 1); ret = i2c_transfer(i2c, &msg, 1); return (ret != 1) ? -EIO : 0; } static struct stv0299_config alps_bsbe1_config = { .demod_address = 0x68, .inittab = alps_bsbe1_inittab, .mclk = 88000000UL, .invert = 1, .skip_reinit = 0, .min_delay_ms = 100, .set_symbol_rate = alps_bsbe1_set_symbol_rate, }; #endif |