// SPDX-License-Identifier: GPL-2.0 /* * drivers/usb/host/xhci-rcar.h * * Copyright (C) 2014 Renesas Electronics Corporation */ #ifndef _XHCI_RCAR_H #define _XHCI_RCAR_H #define XHCI_RCAR_FIRMWARE_NAME_V1 "r8a779x_usb3_v1.dlmem" #define XHCI_RCAR_FIRMWARE_NAME_V2 "r8a779x_usb3_v2.dlmem" #define XHCI_RCAR_FIRMWARE_NAME_V3 "r8a779x_usb3_v3.dlmem" #if IS_ENABLED([31mCONFIG_USB_XHCI_RCAR[0m) void xhci_rcar_start(struct usb_hcd *hcd); int xhci_rcar_init_quirk(struct usb_hcd *hcd); int xhci_rcar_resume_quirk(struct usb_hcd *hcd); #else static inline void xhci_rcar_start(struct usb_hcd *hcd) { } static inline int xhci_rcar_init_quirk(struct usb_hcd *hcd) { return 0; } static inline int xhci_rcar_resume_quirk(struct usb_hcd *hcd) { return 0; } #endif /* * On R-Car Gen2 and Gen3, the AC64 bit (bit 0) of HCCPARAMS1 is set * to 1. However, these SoCs don't support 64-bit address memory * pointers. So, this driver clears the AC64 bit of xhci->hcc_params * to call dma_set_coherent_mask(dev, DMA_BIT_MASK(32)) in * xhci_gen_setup() by using the XHCI_NO_64BIT_SUPPORT quirk. * * And, since the firmware/internal CPU control the USBSTS.STS_HALT * and the process speed is down when the roothub port enters U3, * long delay for the handshake of STS_HALT is neeed in xhci_suspend() * by using the XHCI_SLOW_SUSPEND quirk. */ #define SET_XHCI_PLAT_PRIV_FOR_RCAR(firmware) \ .firmware_name = firmware, \ .quirks = XHCI_NO_64BIT_SUPPORT | XHCI_TRUST_TX_LENGTH | \ XHCI_SLOW_SUSPEND, \ .init_quirk = xhci_rcar_init_quirk, \ .plat_start = xhci_rcar_start, \ .resume_quirk = xhci_rcar_resume_quirk, #endif /* _XHCI_RCAR_H */ |