Training courses

Kernel and Embedded Linux

Bootlin training courses

Embedded Linux, kernel,
Yocto Project, Buildroot, real-time,
graphics, boot time, debugging...

Bootlin logo

Elixir Cross Referencer

Toshiba et8ek8 5MP sensor

Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device

More detailed documentation can be found in
Documentation/devicetree/bindings/media/video-interfaces.txt .


Mandatory properties
--------------------

- compatible: "toshiba,et8ek8"
- reg: I2C address (0x3e, or an alternative address)
- vana-supply: Analogue voltage supply (VANA), 2.8 volts
- clocks: External clock to the sensor
- clock-frequency: Frequency of the external clock to the sensor. Camera
  driver will set this frequency on the external clock. The clock frequency is
  a pre-determined frequency known to be suitable to the board.
- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
  is in hardware standby mode when the signal is in the low state.


Optional properties
-------------------

- flash-leds: See ../video-interfaces.txt
- lens-focus: See ../video-interfaces.txt


Endpoint node mandatory properties
----------------------------------

- remote-endpoint: A phandle to the bus receiver's endpoint node.


Example
-------

&i2c3 {
	clock-frequency = <400000>;

	cam1: camera@3e {
		compatible = "toshiba,et8ek8";
		reg = <0x3e>;
		vana-supply = <&vaux4>;
		clocks = <&isp 0>;
		clock-frequency = <9600000>;
		reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
		port {
			csi_cam1: endpoint {
				remote-endpoint = <&csi_out1>;
			};
		};
	};
};