# SPDX-License-Identifier: GPL-2.0-only # # VIA device configuration # config [31mCONFIG_NET_VENDOR_VIA[0m bool "VIA devices" default y ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about VIA devices. If you say Y, you will be asked for your specific card in the following questions. if [31mCONFIG_NET_VENDOR_VIA[0m config [31mCONFIG_VIA_RHINE[0m tristate "VIA Rhine support" depends on [31mCONFIG_PCI[0m || ([31mCONFIG_OF_IRQ[0m && [31mCONFIG_GENERIC_PCI_IOMAP[0m) depends on [31mCONFIG_HAS_DMA[0m select [31mCONFIG_CRC32[0m select [31mCONFIG_MII[0m ---help--- If you have a VIA "Rhine" based network card (Rhine-I (VT86C100A), Rhine-II (VT6102), or Rhine-III (VT6105)), say Y here. Rhine-type Ethernet functions can also be found integrated on South Bridges (e.g. VT8235). To compile this driver as a module, choose [31mCONFIG_M[0m here. The module will be called via-rhine. config [31mCONFIG_VIA_RHINE_MMIO[0m bool "Use MMIO instead of PIO" depends on [31mCONFIG_VIA_RHINE[0m ---help--- This instructs the driver to use [31mCONFIG_PCI[0m shared memory (MMIO) instead of programmed I/O ports (PIO). Enabling this gives an improvement in processing time in parts of the driver. If unsure, say Y. config [31mCONFIG_VIA_VELOCITY[0m tristate "VIA Velocity support" depends on ([31mCONFIG_PCI[0m || ([31mCONFIG_OF_ADDRESS[0m && [31mCONFIG_OF_IRQ[0m)) depends on [31mCONFIG_HAS_DMA[0m select [31mCONFIG_CRC32[0m select [31mCONFIG_CRC_CCITT[0m select [31mCONFIG_MII[0m ---help--- If you have a VIA "Velocity" based network card say Y here. To compile this driver as a module, choose [31mCONFIG_M[0m here. The module will be called via-velocity. endif # [31mCONFIG_NET_VENDOR_VIA[0m |