/* $NetBSD: bth5.h,v 1.2 2017/09/03 23:11:19 nat Exp $ */
/*
* Copyright (c) 2017 Nathanial Sloss <nathanialsloss@yahoo.com.au>
* All rights reserved.
*
* Copyright (c) 2007 KIYOHARA Takashi
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
* WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
* DISCLAIMED. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT,
* INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
* (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
* SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
* STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
* ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/
#ifndef _DEV_BLUETOOTH_BTH5_H_
#define _DEV_BLUETOOTH_BTH5_H_
/*
* BT UART H5 (3-wire) serial protocol definitions.
*/
/* BTH5 packet header */
typedef struct {
uint8_t flags;
#if BYTE_ORDER == BIG_ENDIAN
uint8_t plen1 :4; /* Payload Length (bits 0-3) */
uint8_t ident :4; /* Protocol Identifier */
#else
uint8_t ident :4; /* Protocol Identifier */
uint8_t plen1 :4; /* Payload Length (bits 0-3) */
#endif
uint8_t plen2; /* Payload Length (bits 4-11) */
uint8_t csum; /* Checksum */
u_char payload[0];
} __packed bth5_hdr_t;
#define BTH5_FLAGS_SEQ_SHIFT 0
#define BTH5_FLAGS_SEQ_MASK 0x07
#define BTH5_FLAGS_SEQ(n) \
(((n) & BTH5_FLAGS_SEQ_MASK) >> BTH5_FLAGS_SEQ_SHIFT)
#define BTH5_FLAGS_ACK_SHIFT 3
#define BTH5_FLAGS_ACK_MASK 0x38
#define BTH5_FLAGS_ACK(n) \
(((n) & BTH5_FLAGS_ACK_MASK) >> BTH5_FLAGS_ACK_SHIFT)
#define BTH5_FLAGS_CRC_PRESENT 0x40
#define BTH5_FLAGS_PROTOCOL_TYPE 0x80
#define BTH5_FLAGS_PROTOCOL_REL 0x80
#define BTH5_CONFIG_ACK_MASK 0x07
#define BTH5_CONFIG_FLOW_MASK (1 << 7)
#define BTH5_SET_PLEN(hdrp, n) \
do { \
(hdrp)->plen1 = ((n) & 0x00f); \
(hdrp)->plen2 = ((n) >> 4); \
} while (0)
#define BTH5_GET_PLEN(hdrp) ((hdrp)->plen1 | ((hdrp)->plen2 << 4))
#define BTH5_GET_CSUM(hdrp) \
(0xff - (uint8_t)((hdrp)->flags + ((hdrp)->plen1 << 4) + \
(hdrp)->ident + (hdrp)->plen2))
#define BTH5_SET_CSUM(hdrp) ((hdrp)->csum = BTH5_GET_CSUM(hdrp))
#define BTH5_IDENT_ACKPKT 0 /* Used by MUX Layer */
/* definitions of SLIP Layer */
#define BTH5_SLIP_PKTSTART 0xc0
#define BTH5_SLIP_PKTEND BTH5_SLIP_PKTSTART
#define BTH5_SLIP_XON 0x11
#define BTH5_SLIP_XOFF 0x13
#define BTH5_SLIP_ESCAPE 0xdb
#define BTH5_SLIP_ESCAPE_PKTEND 0xdc
#define BTH5_SLIP_ESCAPE_ESCAPE 0xdd
#define BTH5_SLIP_ESCAPE_XON 0xde
#define BTH5_SLIP_ESCAPE_XOFF 0xdf
/* definitions of Sequencing Layer */
#define BTH5_SEQ_TX_TIMEOUT (hz / 4) /* 250 msec */
#define BTH5_SEQ_TX_WINSIZE 7
#define BTH5_SEQ_TX_RETRY_LIMIT 20
/*
* Channel Allocation
*/
#define BTH5_CHANNEL_HCI_CMD 1 /* HCI Command and Event */
#define BTH5_CHANNEL_HCI_EVT 4 /* HCI Command and Event */
#define BTH5_CHANNEL_HCI_ACL 2 /* HCI ACL data */
#define BTH5_CHANNEL_HCI_SCO 3 /* HCI SCO data */
#define BTH5_CHANNEL_LE 15 /* Link Establishment */
/*
* Link Establishment Protocol
*/
typedef enum {
le_state_shy,
le_state_curious,
le_state_garrulous
} bth5_le_state_t;
#define BTH5_LE_SYNC { 0x01, 0x7e };
#define BTH5_LE_SYNCRESP { 0x02, 0x7d };
#define BTH5_LE_CONF { 0x03, 0xfc, 0x0f };
#define BTH5_LE_CONFRESP { 0x04, 0x7b, 0x0f };
#define BTH5_LE_TSHY_TIMEOUT hz /* XXXX: 1sec ? */
#define BTH5_LE_TCONF_TIMEOUT hz /* XXXX: 1sec ? */
#endif /* !_DEV_BLUETOOTH_BTH5_H_ */