/* $NetBSD: mb89352reg.h,v 1.6 2005/12/11 12:21:27 christos Exp $ */
/* NecBSD: mb89352reg.h,v 1.3 1998/03/14 07:04:34 kmatsuda Exp */
/*-
* Copyright (c) 1996,97,98,99 The NetBSD Foundation, Inc.
* All rights reserved.
* Copyright (c) 1990, 1993
* The Regents of the University of California. All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Charles M. Hannum, Masaru Oki and Kouichi Matsuda.
*
* This code is derived from software contributed to Berkeley by
* Van Jacobson of Lawrence Berkeley Laboratory.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. Neither the name of the University nor the names of its contributors
* may be used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*
* @(#)scsireg.h 8.1 (Berkeley) 6/10/93
*/
/*
* [NetBSD for NEC PC-98 series]
* Copyright (c) 1996, 1997, 1998
* NetBSD/pc98 porting staff. All rights reserved.
* Copyright (c) 1996, 1997, 1998
* Kouichi Matsuda. All rights reserved.
*/
/*
* FUJITSU MB89352A SCSI Protocol Controller Hardware Description.
*/
/* Definitions, most of them has turned out to be unneccesary, but here they
* are anyway.
*/
#define BDID 0x00 /* Bus Device ID (R/W) */
#define SCTL 0x01 /* SPC Control register (R/W) */
#define SCMD 0x02 /* Command Register (R/W) */
#define TMOD 0x03 /* Transmit Mode Register (synch models) */
#define INTS 0x04 /* Interrupt sense (R); Interrupt Reset (W) */
#define PSNS 0x05 /* Phase Sence (R); SPC Diagnostic Control (W) */
#define SSTS 0x06 /* SPC status (R/O) */
#define SERR 0x07 /* SPC error status (R/O) */
#define PCTL 0x08 /* Phase Control (R/W) */
#define MBC 0x09 /* Modified Byte Counter (R/O) */
#define DREG 0x0a /* Data Register (R/W) */
#define TEMP 0x0b /* Temporary Register (R/W) */
#define TCH 0x0c /* Transfer Counter High (R/W) */
#define TCM 0x0d /* Transfer Counter Middle (R/W) */
#define TCL 0x0e /* Transfer Counter Low (R/W) */
#define EXBF 0x0f /* External Buffer (synch models) */
/* What all the bits do */
/* SCSI_BDID */
/* SCSI selection/reselection ID (both target *and* initiator) */
#define SELID7 0x80
#define SELID6 0x40
#define SELID5 0x20
#define SELID4 0x10
#define SELID3 0x08
#define SELID2 0x04
#define SELID1 0x02
#define SELID0 0x01
/* SCSI_SCTL */
#define SCTL_DISABLE 0x80
#define SCTL_CTRLRST 0x40
#define SCTL_DIAG 0x20
#define SCTL_ABRT_ENAB 0x10
#define SCTL_PARITY_ENAB 0x08
#define SCTL_SEL_ENAB 0x04
#define SCTL_RESEL_ENAB 0x02
#define SCTL_INTR_ENAB 0x01
/* SCSI_SCMD */
#define SCMD_RST 0x10
#define SCMD_ICPT_XFR 0x08
#define SCMD_PROG_XFR 0x04
#define SCMD_PAD 0x01 /* if initiator */
#define SCMD_PERR_STOP 0x01 /* if target */
/* command codes */
#define SCMD_BUS_REL 0x00
#define SCMD_SELECT 0x20
#define SCMD_RST_ATN 0x40
#define SCMD_SET_ATN 0x60
#define SCMD_XFR 0x80
#define SCMD_XFR_PAUSE 0xa0
#define SCMD_RST_ACK 0xc0
#define SCMD_SET_ACK 0xe0
/* SCSI_TMOD */
#define TMOD_SYNC 0x80
/* SCSI_INTS */
#define INTS_SEL 0x80
#define INTS_RESEL 0x40
#define INTS_DISCON 0x20
#define INTS_CMD_DONE 0x10
#define INTS_SRV_REQ 0x08
#define INTS_TIMEOUT 0x04
#define INTS_HARD_ERR 0x02
#define INTS_RST 0x01
/* SCSI_PSNS */
#define PSNS_REQ 0x80
#define PSNS_ACK 0x40
#define PSNS_ATN 0x20
#define PSNS_SEL 0x10
#define PSNS_BSY 0x08
/* PSNS */
#define REQI 0x80
#define ACKI 0x40
#define ATNI 0x20
#define SELI 0x10
#define BSYI 0x08
#define MSGI 0x04
#define CDI 0x02
#define IOI 0x01
/* Important! The 3 most significant bits of this register, in initiator mode,
* represents the "expected" SCSI bus phase and can be used to trigger phase
* mismatch and phase change interrupts. But more important: If there is a
* phase mismatch the chip will not transfer any data! This is actually a nice
* feature as it gives us a bit more control over what is happening when we are
* bursting data (in) through the FIFOs and the phase suddenly changes from
* DATA IN to STATUS or MESSAGE IN. The transfer will stop and wait for the
* proper phase to be set in this register instead of dumping the bits into the
* FIFOs.
*/
#if 0
#define REQO 0x80
#define ACKO 0x40
#define ATNO 0x20
#define SELO 0x10
#define BSYO 0x08
#endif
/* PCTL */
#define MSGO 0x04
#define CDO 0x02
#define IOO 0x01
/* Information transfer phases */
#define PH_DATAOUT (0)
#define PH_DATAIN (IOI)
#define PH_CMD (CDI)
#define PH_STAT (CDI | IOI)
#define PH_MSGOUT (MSGI | CDI)
#define PH_MSGIN (MSGI | CDI | IOI)
#define PH_MASK (MSGI | CDI | IOI)
#define PH_INVALID 0xff
/* SCSI_SSTS */
#define SSTS_INITIATOR 0x80
#define SSTS_TARGET 0x40
#define SSTS_BUSY 0x20
#define SSTS_XFR 0x10
#define SSTS_ACTIVE (SSTS_INITIATOR|SSTS_XFR)
#define SSTS_RST 0x08
#define SSTS_TCZERO 0x04
#define SSTS_DREG_FULL 0x02
#define SSTS_DREG_EMPTY 0x01
/* SCSI_SERR */
#define SERR_SCSI_PAR 0x80
#define SERR_SPC_PAR 0x40
#define SERR_TC_PAR 0x08
#define SERR_PHASE_ERR 0x04
#define SERR_SHORT_XFR 0x02
#define SERR_OFFSET 0x01
/* SCSI_PCTL */
#define PCTL_BFINT_ENAB 0x80